On a dual printer head setup I'm seeing weird behaviour where the priming tower is printed at the end of the layer, on the first layer. This is causing me massive headaches when I'm trying to print with dissolvable filament. Not sure if this is the intended behaviour but this only happens on the first layer and would seem like a rather weird way of handing this.
Printer: Flashforge Creator Pro
Version: 4.0
Left: PVA 195
Right: PLA 200
-
freezerohmatic
- Posts: 2
- Joined: Sat Jan 27, 2018 12:42 am
Re: Primer tower bug
I’m happy to say that this issue should be resolved now in the latest 4.1.0 release. Our team successfully tested tons of prints with this enabled. The Prime Pillar now prints prior to that layer's models. This was just one of many improvements to the software. All of which are detailed on our Release Notes page.
Thank you for your help reporting this issue!
Thank you for your help reporting this issue!
"A bird does not sing because it has an answer. It sings because it has a song."
