Simplify3D User Forum

Hi all

I've just got my S3D and my first print was a simple calibration tool - I wanted to compare to Cura.
I have to say I was a little disappointed in the results... see the photos attached - S3D on the left, Cura on the right.
As you can see there seems to be some inconsistency on the corners.

Both are with very much default settings and after printing a mobile phone stand for my daughter in S3D (which has come out more-than fine) I am wondering if it's the model itself and some way in which S3D deals with it differently?

The cube is from https://www.thingiverse.com/thing:1278865

Any help/suggestions appreciated.

Hey there, were you able to resolve this issue? I seem to have the same issue, also, another user apparently is having the same issue as well on this post: viewtopic.php?f=9&t=9653.