Default File Name
Posted: Fri Mar 16, 2018 4:06 pm
I Have my S3D setup to save and upload straight to Octoprint.
I run most of my prints out of the same workspace, so as to share my current print settings.
This is frustrating however, because every time I go to save a gcode file, the name of the first file I added to the workspace is the default name of the gcode file, whereas it should at least consider if the file was selected for printing, and if not maybe suggest a file name that is?
I run most of my prints out of the same workspace, so as to share my current print settings.
This is frustrating however, because every time I go to save a gcode file, the name of the first file I added to the workspace is the default name of the gcode file, whereas it should at least consider if the file was selected for printing, and if not maybe suggest a file name that is?