Page 1 of 1
Preview Mode without Filament Width
Posted: Thu Mar 29, 2018 3:37 am
by cncandi
See in attachment. In case of preview I can show only Travel moves but not Filament.
What is my mistake?
Re: Preview Mode without Filament Width
Posted: Thu Mar 29, 2018 4:00 am
by rrdavis
Can you post the factory file that you used to create this gcode file? File > Save Factory File
Re: Preview Mode without Filament Width
Posted: Thu Apr 05, 2018 5:24 am
by cncandi
I have found the problem. If I select 5D firmware it works fine. Without there is no preview.