Page 1 of 1
100% infill but still not completely full infill
Posted: Wed Apr 04, 2018 3:52 am
by mstein
I set 100% infill, but still it is not completely filled on top. Why?
Attached a screenshot of slicing and the settings.
Thanks.
Re: 100% infill but still not completely full infill
Posted: Wed Apr 04, 2018 3:54 am
by mellons
Can you upload a picture of your Advanced Settings too, please.
Re: 100% infill but still not completely full infill
Posted: Wed Apr 04, 2018 4:51 am
by dkightley
Increase the Infill overlap to something like 80% and change the Minimum Infill Length to zero. The small cylindrical top should then fill.
Re: 100% infill but still not completely full infill
Posted: Wed Apr 04, 2018 5:09 am
by mstein
Great! That was the solution. Thanks!