Search found 6 matches

Go to advanced search

by Obfuscated
Tue Sep 10, 2013 12:16 pm
Forum: General Discussion and Tips
Topic: bad vibration
Replies: 5
Views: 2224

Re: bad vibration

It's also possible the the nozzle is hitting the previous layer. Your settings may be extruding too much plastic which is causing rough layers.
by Obfuscated
Tue Sep 10, 2013 12:13 pm
Forum: General Discussion and Tips
Topic: Is anyone having luck printing .1 mm with Replicator 2x?
Replies: 5
Views: 2115

Re: Is anyone having luck printing .1 mm with Replicator 2x

I am fighting with mt 2x on .2 mm . Could you give me a hint where your importations are around? I use right now Nozzle .4 Width .36 Multiplier 1.1 I am not totally satisfied with the result These seam totally different from your .1 values. Can you help me underfunding these parameters? Nozzle is o...
by Obfuscated
Fri Jul 19, 2013 11:28 pm
Forum: General Discussion and Tips
Topic: Is anyone having luck printing .1 mm with Replicator 2x?
Replies: 5
Views: 2115

Re: Is anyone having luck printing .1 mm with Replicator 2x

So after alot of fiddling I've been able to do some decent prints at layer heights of .1.

Extrusion Diameter .4 mm
Auto Extrusion Width .9 mm
Extrusion Multiplier .7 mm
by Obfuscated
Sun Jul 07, 2013 9:15 pm
Forum: General Discussion and Tips
Topic: Is anyone having luck printing .1 mm with Replicator 2x?
Replies: 5
Views: 2115

Is anyone having luck printing .1 mm with Replicator 2x?

Is anyone having luck printing .1 mm layers with Replicator 2x? If so what settings are you using?
by Obfuscated
Sun Jul 07, 2013 3:42 pm
Forum: Troubleshooting and Bug Reports
Topic: I like this package but need some help...
Replies: 13
Views: 6894

Re: I like this package but need some help...

I have at issue too, if printing at low layer heights where other slicers work fine. There seems to be a gap between each line instead of making it run up next to it. Like it is calculating the next move slightly off leaving a gap between bigger then the plastic can fill. I'm having the same issues...
by Obfuscated
Sun Jul 07, 2013 2:43 pm
Forum: General Discussion and Tips
Topic: Creator 1.1.4 Update
Replies: 10
Views: 3903

Re: Creator 1.1.4 Update

I have a Replicator X2 and I have a trial version of Simplify. I'm having issues with slicing anything below .17; when I slice at .1 I get alot of violent shaking when it prints curves and the extrusions are blobby. Also the default settings for temperatures were lower than I expected. Is there a re...

Go to advanced search