Search found 7 matches
- Fri May 15, 2015 5:47 pm
- Forum: General Discussion and Tips
- Topic: More Complete Support
- Replies: 11
- Views: 8545
- Jump to post
Re: More Complete Support
As I was typing the last response I decided to check out the uprint version of the print. It seemed very strong...so I crushed it open only to find a support structure inside! I guess I'll need to add this support manually since the Simplfy 3D did not generate support.
- Fri May 15, 2015 5:45 pm
- Forum: General Discussion and Tips
- Topic: More Complete Support
- Replies: 11
- Views: 8545
- Jump to post
Re: More Complete Support
That post is not exactly applicable. This model is hollow inside (hollow round ball), so in-fill does not apply. I printed the same on a uPrint and it came perfect.
- Fri May 15, 2015 2:30 pm
- Forum: General Discussion and Tips
- Topic: More Complete Support
- Replies: 11
- Views: 8545
- Jump to post
Re: More Complete Support
I set the separation from the part to 0, used PVA as a support (removing HIPS is messy) and got good results. Even the uprint I have has problems with the model. Now I have problems with the top (see pic). The plastic barley touches and it can nearly be pushed in.
- Wed May 13, 2015 7:22 pm
- Forum: General Discussion and Tips
- Topic: More Complete Support
- Replies: 11
- Views: 8545
- Jump to post
Re: More Complete Support
Well... I what I was trying to fix with using a better support did not get fixed. While the support was good, the print was bad. I think I have another problem. See pic
- Tue May 12, 2015 11:33 am
- Forum: General Discussion and Tips
- Topic: More Complete Support
- Replies: 11
- Views: 8545
- Jump to post
Re: More Complete Support
Thnaks. Ill try and report back. My first try will be with ABS and PVA. I have a uprint and flashforge and am trying to make the flashforge print as nice as the uprint. Im starting to print test prints on each to see how the layers stack up. I have a parts with a hole near an outside edge. The uprin...
- Thu May 07, 2015 6:59 pm
- Forum: General Discussion and Tips
- Topic: More Complete Support
- Replies: 11
- Views: 8545
- Jump to post
More Complete Support
I plan to use my Flashforge Creator Pro with a PVA or HIP support material. How do I get a more complete support framework similar to how a Stratasys printer does with its support? I will be printing objects with lots of curves, and using the existing support always leaves the underside curved featu...
- Sun Sep 08, 2013 2:25 am
- Forum: Troubleshooting and Bug Reports
- Topic: First Layer Issues
- Replies: 14
- Views: 11115
- Jump to post
Re: First Layer Issues
I have a similar issues on my M2 with abs EXCEPT i did not use the manual extrusion option. Will this be corrected or can I get a refund? My Z-height is set to .1mm and I just re-checked it.
