Simplify3D User Forum

dodgersfan24

Well ok, changing the angles is almost the same. But I do think my other ideas would be very useful.

dodgersfan24

Thank you, that helps.

dodgersfan24

Usually I find myself printing large models with 0% infill, with 7-10 top layers on my prints. Works well for me. Occasionally, a model requires something to hold the beginning of a top layer. Such as a large cube, or something with a cone shaped dip in the middle. For this I have always restored to...

dodgersfan24

Usually I create and edit models with blender. I set it to metric, and scale to 1. When I import my STL's, it says Part appears to be extreamly small and may be in inches format. Would you like to automatically scale to millimeter format? I click no as always, then change scale from 1 to 1000. And g...

dodgersfan24

I noticed its not an option to check mark anymore?

dodgersfan24

Your right, it does print the wall before the infill. But it does make little difference, but not enough. I reprinted the part with the original problem, and it occurred again. But I did try using hot clue in corners of raft, and got 0 warping for the first time in this part. Never tried glue stick ...

dodgersfan24

@Darthraven No on the cubes had a similar process. Only difference in between the cubes, on one I had solid layers on top and bottom between the process. They didn't effect either print. Probably because of strait edges. Just as the sides of my prints seem fine. As Tri-Lite said. I took apart my mes...

dodgersfan24

I printed out the part again and it still happened. Far less, but still visible. I removed the bottom and top layers between processes, and only left infill. It doesn't seem visible on vertical edges. Here are pictures and factory file if someone would be kind to check it out. https://www.mediafire....

dodgersfan24

try removing the top and bottom layers where the processes meet. those should be set to zero. this way the build will run all the way up with infill like it normally would with a single process. if that doesnt do it can you post the factory file? I printed 2 cubes, one without the top and bottom la...

dodgersfan24

Yes, the stop and start points match. And I don't see any gaps. My thought is that the problem starts when it builds the top and bottom layers of the last two processes. Which starts in the previous process. When laying down the 3 solid layers, it seems to be putting plastic on the walls. I'm going ...

Search found 18 matches

Re: Features that help large hallow prints. Random infill.

Re: Importing Small Scaled models.

Features that help large hallow prints. Random infill.

Importing Small Scaled models.

What happened to randomizing infill in 3.0?

Re: Shift when starting print in new process with infill

Re: Shift when starting print in new process with infill

Re: Shift when starting print in new process with infill

Re: Shift when starting print in new process with infill

Re: Shift when starting print in new process with infill