Simplify3D User Forum

over-$-pent

Previous to version 3.0, when you highlighted a process in the processes window and clicked "prepare to print", that process was automatically highlighted in the "select processes for printing" window and you could just pick OK to proceed. In version 3.0, when you highlight a pro...

over-$-pent

Is this ABS? If so, it could be separation. On your multiple processes, are you turning off top solid layers on the first process and bottom solid layers on the second process to have a continuous print without solid layers where the processes end and begin? That also might cause some issues.

over-$-pent

To handle nearly flat areas, I use 2 processes. In your case: First Process - change to zero top solid layers and stop printing at 56mm, leaving all other settings the same. Second Process - zero bottom layers and 4 top solid layers, first layer speed to 100%, infill to 100%, start printing at 56mm....

over-$-pent

more than + 1 on this. I always battle that issue. Thanks for bringing it up as a fix that is needed.

over-$-pent

Its one thing to have multiple parts that you can use sequential printing to help, but I doubt 90% can be removed. In the case below, this is a single part that I forwarded to S3D for help, but the only offer was to use coasting, wipe, and retraction to minimize ooze. That does not work well with ni...

over-$-pent

It is hard to tell, but is that the first, second, or third layer? I would use auto extrusion width instead of manual at .4. Have you done a calibration box to check / set your extrusion multiplier? What is your nozzle to bed height at Z zero? Check those items and let us know.

over-$-pent

I am an S3d user and have emailed support about this same problem, without any remedy given. It is a big problem, especially with ooze prone materials like ninja flex. It is a very inefficient use of travel moves. I have recently researched Slic3r and it has a setting called "avoid crossing per...

over-$-pent

When using the preview by layer or line, the only options to move through the layers / lines is to use the horizontal scroll bar or the arrows at the far right of the screen. Can you add the ability to use the left/right arrow keys on the keyboard to move through the layers or lines? Either using th...

over-$-pent

It would be very helpful to have the ability to view multiple "FFF settings" pages when editing processes. I always find myself viewing different tabs in different processes to see what settings I had used previously or changed. The ability to have 2 or more process pages open side by side...

Search found 9 matches

Processes to prepare to print different S3D 2.0 to 3.0

Re: Shift when starting print in new process with infill

Re: Last layer troubles

Re: Stop Auto Top View- Moving Parts

Re: Prevent nozzle(s) crossing perimeters of models

Re: Infill layers loose

Re: Prevent nozzle(s) crossing perimeters of models

Preview by layer or line improvement

Edit Process Settings