Search found 6 matches
- Sat Mar 19, 2016 7:57 pm
- Forum: General Discussion and Tips
- Topic: 3D Print offset
- Replies: 4
- Views: 1805
- Jump to post
Re: 3D Print offset
No changes made to any profile. I am thinking of importing the firmware profile tho ?
- Fri Mar 18, 2016 8:40 am
- Forum: General Discussion and Tips
- Topic: 3D Print offset
- Replies: 4
- Views: 1805
- Jump to post
3D Print offset
Even tho I have had this software for some time now I am finally trying to using it. I have a problem. When I start printing it is WAY off set. It leaves a blob in the middle of the BED. And starts printing in the far Right of the bed. Half of the print is on the Bed and the other half is off the be...
- Sat Oct 17, 2015 12:40 pm
- Forum: General Discussion and Tips
- Topic: Infill percentage
- Replies: 4
- Views: 2703
- Jump to post
Re: Infill percentage
Ok, I purchased the program. But haven't had a chance to play with it yet. I am SURE I will have more questions.
- Thu Oct 15, 2015 8:31 pm
- Forum: General Discussion and Tips
- Topic: Infill percentage
- Replies: 4
- Views: 2703
- Jump to post
Re: Infill percentage
Yup, it's really easy to do with S3D process system. Here's two tutorials that explain the subject: https://www.simplify3d.com/support/tutorials/different-settings-for-different-regions-of-a-model/ https://www.simplify3d.com/support/tutorials/multi-part-printing/ This looks fine for models that née...
- Wed Oct 14, 2015 12:45 pm
- Forum: General Discussion and Tips
- Topic: Infill percentage
- Replies: 4
- Views: 2703
- Jump to post
Infill percentage
I have heard there there is a way to have parts of your model filled with lets say 75% infill. And you can have the other parts filled at 10%. Is this possible ? Because I want only parts of a model filled in more then other parts for strength. Do you have any videos on how to do this ?
- Sat Oct 10, 2015 11:46 am
- Forum: General Discussion and Tips
- Topic: Makerbot Rep 2 with Sailfish
- Replies: 2
- Views: 2642
- Jump to post
Makerbot Rep 2 with Sailfish
Do you have your program set up for a Makerbot Rep 2 WITH sailfish firmware installed ? I know you should already have it set up for printers that have the Makerbot firmware. Thinking of updating the firmware TO Sailfish anyone have any thoughts on this as well ?
