Search found 3 matches
- Sat Mar 12, 2016 11:23 am
- Forum: Troubleshooting and Bug Reports
- Topic: 2 Processes 1 with a skirt, one with a regular Brim
- Replies: 2
- Views: 1196
- Jump to post
Re: 2 Processes 1 with a skirt, one with a regular Brim
If the parts are too close together on your bed, they will end up using the same brim settings since their brims would otherwise overlap. So make sure the parts are far enough apart if you want different brims with different settings. After messing around with it shortly after I posted the topic *U...
- Sat Mar 12, 2016 1:52 am
- Forum: Troubleshooting and Bug Reports
- Topic: 2 Processes 1 with a skirt, one with a regular Brim
- Replies: 2
- Views: 1196
- Jump to post
2 Processes 1 with a skirt, one with a regular Brim
I have a few small parts I need to print, but I have 2 processes to print multiple pieces. Process 1 (PLA) has the same settings are Process 2 (PLA-Brim) but the smaller parts that require the brim are selected and the parts that don't use process 1. I just did it a few mins ago and sliced up some f...
- Sun Feb 14, 2016 11:34 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Having an issue with the hotend scaring the layer.
- Replies: 1
- Views: 926
- Jump to post
Having an issue with the hotend scaring the layer.
I know this topic is covered in the support section, but when I follow the directions it still happens, also I noticed the Retraction Vertical Lift only applies when the current layer is finished and it's going to start a new layer. The issue I am having is when it's doing say a full 1st layer, or 2...
