Search found 4 matches
- Thu May 26, 2016 5:11 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Ghosting on prints with recessed features
- Replies: 2
- Views: 2552
- Jump to post
Re: Ghosting on prints with recessed features
Have you taken a look at this?? https://www.simplify3d.com/support/print-quality-troubleshooting/#vibrations-and-ringing I have looked at the guide but wasn't sure if that was what I was seeing here. I will adjust my printing speed and movement speed to see if this helps. Thank you for the response.
- Thu May 26, 2016 4:15 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Ghosting on prints with recessed features
- Replies: 2
- Views: 2552
- Jump to post
Ghosting on prints with recessed features
Hello, I have ran into some issues with what looks like "ghosting" when printing recessed features. Below I have attached a photo which will show what I am talking about. As you can see to the right of the apple it appears that this design continues to the right of the print and I would li...
- Sun Mar 06, 2016 11:24 pm
- Forum: General Discussion and Tips
- Topic: Printing parts at different %'s
- Replies: 1
- Views: 979
- Jump to post
Re: Printing parts at different %'s
Tap on the "Select Models" button in the bottom left of your "FFF Settings".
- Sun Mar 06, 2016 11:21 pm
- Forum: General Discussion and Tips
- Topic: FlashForge ABS on Borosilicate Glass Won't Stick
- Replies: 9
- Views: 7035
- Jump to post
Re: FlashForge ABS on Borosilicate Glass Won't Stick
There are many things people have used to get ABS to stick to glass. One thing you could try is Aquanet Hairspray. Make sure if you use hairspray that you remove the glass from the bed before spraying it so that you don't gunk up any internals. Also you could try using ABS juice as mentioned. To mak...
