Search found 7 matches
- Fri Oct 06, 2017 1:09 pm
- Forum: Feature Requests
- Topic: Prime Pillar Extrusion Multiplier
- Replies: 1
- Views: 1416
- Jump to post
Re: Prime Pillar Extrusion Multiplier
For everyone having similar problems, here ist my post processing script, that kind of solves the problem: {REPLACE "; ooze shield" "; ooze shield\nM221 S140"} {REPLACE "; prime pillar" "; prime pillar\nM221 S140"} {REPLACE "; skirt" "; skirt\nM...
- Fri Oct 06, 2017 11:56 am
- Forum: Feature Requests
- Topic: API for add-ins
- Replies: 37
- Views: 36710
- Jump to post
- Fri Oct 06, 2017 9:08 am
- Forum: Feature Requests
- Topic: Prime Pillar Extrusion Multiplier
- Replies: 1
- Views: 1416
- Jump to post
Prime Pillar Extrusion Multiplier
Hello! I'm printing a lot with PLA and PETG. They don't stick together very well, so they are the perfect combination for parts that need support. Prime pillars higher than about 5cm always suffer from delamination, in my case. To solve this problem, a extrusion multiplier for the prime pillar would...
- Thu Nov 10, 2016 1:34 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Dual Extrusion - First Retraction
- Replies: 15
- Views: 15734
- Jump to post
Re: Dual Extrusion - First Retraction
Thanks a lot, I will give it a try 
- Tue Nov 08, 2016 12:35 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Dual Extrusion - First Retraction
- Replies: 15
- Views: 15734
- Jump to post
Dual Extrusion - First Retraction
Hi guys, I'm not new to dual extrusion, but after a hole lot of trouble with tow hotends and a E3d Cyclops I decided to try out a single hotend, dual extruder concept. The filament which is fed to the hotend gets switched in a Y piece before it enters the Hotend. Like this: http://www.thingiverse.co...
- Fri Mar 11, 2016 6:23 am
- Forum: General Discussion and Tips
- Topic: Different Layerheight for Infill
- Replies: 2
- Views: 1389
- Jump to post
Re: Different Layerheight for Infill
Thank you very much
- Thu Mar 10, 2016 5:20 pm
- Forum: General Discussion and Tips
- Topic: Different Layerheight for Infill
- Replies: 2
- Views: 1389
- Jump to post
Different Layerheight for Infill
Hi, I did some experiments with a 1,5mm nozzle on my Mendel90 with two extruders. The results were very promising considering the super fast printing speed. I was wondering, if it is possible to print the inside of a part with a higher layerheight than the outside, to get a nice finish on large mode...
