Simplify3D User Forum

croadfeldt

In my opinion Simplify3d should have included the required libcrypto.so.1.0.0 library or compiled it staticlty. This feels like a packaging issue more than anything. Fedora is doing the correct thing when they updated the version to 1.0.2. That was the current version released roughly when they lock...

croadfeldt

In the layer tab you can select the number of top and bottom layers. set top layers to 0 hope this was what you were looking for becky Yeah, the issue is I need top layers because of the slope involved doesn't allow for a reasonable number of shells to have layers without gaps. So I need top layers...

croadfeldt

I am printing the Bonsai Planter by gCreate and need to have top layers in order to print some of the slopes correctly. I could use stop and start printing functionality, but that a top layer blocking off most of the main volume of the planter. The perfect solution would be to be able to cut off the...

croadfeldt

Nice, thanks!

I saw that and didn't put 2 and 2 together to understand that it woud extrude more...

TGIF!

croadfeldt

Greetings all, I've search the forums a bit for this, but no luck so posting. I print a lot in petg. I've noticed that the infill globs up a bit and in my experience that happens because too little is extruded during infill. My perimeters are perfect. The issue is only with infill, and it's one I've...

Search found 5 matches

Re: S3D version 3.1 error in Fedora Core

Re: Cutoff top aka top layers with open top.

Cutoff top aka top layers with open top.

Re: Infill extrusion multiplier

Infill extrusion multiplier