Search found 3 matches
- Sun May 03, 2020 1:40 am
- Forum: General Discussion and Tips
- Topic: Paid upgrade For 2020 upcoming Version 5.0
- Replies: 123
- Views: 532432
- Jump to post
Re: Paid upgrade For 2020 upcoming Version 5.0
I did a trial of Simplify3d in 2016 because of a difficult print-in-place model of a Robot that I couldn't get printed without plastic fusing using Cura and Slicer. I spent a ton of time tweaking both slicers and getting better results but still couldn't reach a point were the plastic didn't fuse pr...
- Sat Sep 03, 2016 11:10 am
- Forum: Troubleshooting and Bug Reports
- Topic: Multiple processes on one object issues
- Replies: 3
- Views: 1452
- Jump to post
Re: Multiple processes on one object issues
OK, It makes sense... I guess after seeing videos where the settings said top and bottom layers were 2 or 3 and then the preview shown nothing. I was thinking it was no supposed to happen.
Thank You
Thank You
- Sat Sep 03, 2016 12:50 am
- Forum: Troubleshooting and Bug Reports
- Topic: Multiple processes on one object issues
- Replies: 3
- Views: 1452
- Jump to post
Multiple processes on one object issues
So I been trying to save plastic and time by using multiple processes with different infills. Now Simplify3D will create what I want but there is a side effect that I have not seen in the example videos. At the height one process starts and one process ends the model ends up with 3 top and 3 bottom ...
