Simplify3D User Forum

popiko

Nobody has a solution

popiko

I put the nozzle higher than normal to see if the problem was for the calibration of the bed, that is not correct but it was to make the video and you can see that that is not the problem

popiko

https://www.youtube.com/watch?v=7JaB0GEeMEg this is de video and problem

popiko

good CompoundCarl also thought it was the height of the layer as in many forums and found that it was one of the solutions, but printed and at a lower height of the bed as if empezase to layer 2, but with those I am still having the same problem, and expulgado if the filament not load prior to print...

popiko

bonne CompoundCarl aussi pensé qu'il était à la hauteur de la couche comme dans de nombreux forums et a constaté que ce fut l'une des solutions, mais et imprimé à une hauteur inférieure du lit comme si empezase à la couche 2, mais avec ceux que je suis encore ayant le même problème, et le expulgado,...

popiko

good fellow, I have a little problem, I have the s3d with qidi and can print without problem, now I an left for a time, a sirius moebyus and connect putting it at home there is no problem, give it a warm bed and one estrusor and no problem charge filament nor, the problem I have when you start print...

popiko

Yo ya lo e comprado y tampoco es muy bueno mi ingles pero poco a poco me voy dando con el, entre vídeos mas algún que otro foro te terminas enterando de como funciona todo! Pero yo también lo quiero en español

popiko

good sreisig1 I have the same problem as you, right now I have put a paper clip so that no hag drop above the printed piece, and not exactly that and playing to change and that this problem does not have it, herewith a video before printing the parts where the problem is explained with it if someone...

popiko

good companion, it might be that was that, but the first line makes test to clean the estrusor while being heated before starting the part if it comes out without any problem and engages well in the blue plate, so I think it may not the problem, it could be some adjustment on the extruder? and not t...

popiko

good morning, I and I have installed without problem and connect with the profile of qidi the problem I have is that when printing the first layer does not come out filament, but by making the test line there is no problem, someone would know tell where it may be the problem? thanks in advance, gree...

Search found 12 matches

Re: mini balls in the first layer

Re: mini balls in the first layer

Re: mini balls in the first layer

Re: mini balls in the first layer

Re: mini balls in the first layer

mini balls in the first layer

Re: In Spanish?

Re: Nozzle Purge Settings with Glass Corner Mounts

Re: qidi tech and first layer

Re: Qidi Tech I Dual Extruder - Print Profile Issues