This happens when the nozzle is too close to the bed. Did you do the bed leveling with both the nozzles and the heated bed at the intended temperature? If you level the bed cold, the nozzle will be too close when heated.popiko wrote:when printing the first layer does not come out filament
Search found 2 matches
- Mon Nov 07, 2016 8:09 am
- Forum: Troubleshooting and Bug Reports
- Topic: Qidi Tech I Dual Extruder - Print Profile Issues
- Replies: 8
- Views: 16905
- Jump to post
Re: Qidi Tech I Dual Extruder - Print Profile Issues
- Sun Sep 25, 2016 8:36 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Indentation/odd formation on a flat surface issue
- Replies: 3
- Views: 1965
- Jump to post
Re: Indentation/odd formation on a flat surface issue
What is the distance between the two shapes? Is it the same as the distance between the two extruders? This happens when the inactive extruder is a little lower than the active one. It drags over the print, lifting the extruder assembly outside the recessed area, but not inside. That creates a secon...
