Search found 2 matches
- Sat Feb 18, 2017 12:26 pm
- Forum: General Discussion and Tips
- Topic: Need help with dual extrusion job
- Replies: 1
- Views: 749
- Jump to post
Need help with dual extrusion job
I'm trying for the first time to use the 2nd extruder on my Mbot cube printer. When the initial layer is being printed, using the left extruder, the right extruder is leaking filament as the first layer goes down. Because of that, I can't get a clean first layer, because eventually the left extruder...
- Thu Dec 08, 2016 10:56 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Nozzle position during purge
- Replies: 2
- Views: 1238
- Jump to post
Nozzle position during purge
I just started experimenting with this software for the first time this evening. I've noticed a problem where during the startup routine for a print job, the nozzles are in a position at the edge of the built plate, and when it purges, the melted filament runs over the side of the plate. Is there a ...
