Search found 3 matches

Go to advanced search

by wermy
Sat Sep 09, 2017 12:00 am
Forum: Feature Requests
Topic: Improvement to "Avoid crossing outline for travel movements"
Replies: 3
Views: 1269

Improvement to "Avoid crossing outline for travel movements"

I'm printing something in flexible TPU material, which is especially susceptible to oozing/stringing. It's a protective sleeve for a device to slide into, and I was trying to reduce the amount of cleanup on the interior I needed to do after printing. Turning on "Avoid crossing outline for travel mov...
by wermy
Sun Jul 23, 2017 11:58 am
Forum: General Discussion and Tips
Topic: Questions about multiple processes
Replies: 2
Views: 628

Questions about multiple processes

Hi, I'm using multiple processes for a print: one set of settings for the first couple layers, then that process stops printing and the other process takes over. I have a couple questions though: Do the first layer settings (first layer height, width, etc) apply on the second process (i.e do those s...
by wermy
Sat Mar 11, 2017 8:50 pm
Forum: Troubleshooting and Bug Reports
Topic: Problems getting settings right after switching nozzle sizes
Replies: 1
Views: 258

Problems getting settings right after switching nozzle sizes

I swapped from a 0.5mm to 0.4mm nozzle on my Taz 6, and I cannot seem to get my settings dialed in properly in Simplify3D. Lines appear waaay too far apart no matter what I do. Here's what it looks like: http://imgur.com/a/5TvC4 First I (duh) changed the nozzle diameter setting. I adjusted the Z-off...

Go to advanced search