Search found 6 matches

Go to advanced search

by rojaljelly
Wed Jan 10, 2018 6:24 am
Forum: General Discussion and Tips
Topic: Having a nightmare with PETG and S3D
Replies: 14
Views: 6529

Re: Having a nightmare with PETG and S3D

The picture looks like printing much too fast...
With my printer I have to set down the speed to 15-25 mm/s (and about 75% for perimeter and infill - first layer at about 40%) depending on the complexity of the printed part.
by rojaljelly
Wed Dec 20, 2017 3:17 am
Forum: General Discussion and Tips
Topic: Having a nightmare with PETG and S3D
Replies: 14
Views: 6529

Re: Having a nightmare with PETG and S3D

I'm printing just fine with PET (I don't use PLA anymore!). The main things I realized are: Printing temperature: data for my filament: 195-220°C - after a few test prints I've got the best results at 220°C Printing Speed: This was my worst problem (delamination betwen 1st and 2nd layer) and this pa...
by rojaljelly
Tue Dec 19, 2017 7:21 am
Forum: General Discussion and Tips
Topic: Auto Configure Setting - PETg?
Replies: 9
Views: 9396

Re: Auto Configure Setting - PETg?

I have changed from PLA to PET completely since I managed to make the prints 99% good. There are so many advantages of the PET compared to PLA but the main reason is that it is Food safe and doesn't react with water. Why there are not more people writing about PET - eventually there will be a preset...
by rojaljelly
Tue Dec 19, 2017 6:40 am
Forum: Troubleshooting and Bug Reports
Topic: Fusion 360 Prints - Scale off?..
Replies: 5
Views: 1545

Re: Fusion 360 Prints - Scale off?..

Hail to the imperial system....
There are sooo many countries still using this complicated system...

Conversion: 1 Inch = 25,4 mm
by rojaljelly
Tue Dec 19, 2017 6:26 am
Forum: Troubleshooting and Bug Reports
Topic: PETG Shell Delamination on Printed Strap
Replies: 5
Views: 2263

Re: PETG Shell Delamination on Printed Strap

I have a pretty similar Problem with my black PET Filament (ICE Filaments). Other coloured PET Filaments are not so bad but I have the same Problems there too. Sometimes after the print you can peel of the 1st layer because the 2nd one isn't bonding to it correctly. http://d3roxcpq5tricw.cloudfront....
by rojaljelly
Tue Dec 19, 2017 5:39 am
Forum: Feature Requests
Topic: New option: Infill Perimeter Outline
Replies: 1
Views: 929

Re: New option: Infill Perimeter Outline

I would absolutely love this Option. Now I have to set a very high infill percentage and a higher number of top layers to get better results. This Option also could have another Setting: Perimeter extention to layers below/above. This will also solve the Problem and guides to more stability of the p...

Go to advanced search