Simplify3D User Forum

24c

I've asked about this before in emails to Support, with no response, so hence this post. Why is the Custom Commands Panel only about 3 customisable macros, I could use a lot more, and this feature is enabled in Printer Host, Matter Control & Print Run too. Simplify3D-MachineControlPanel-CustomCo...

24c

...which leaves the idle nozzle at temperature for the entire layer even if it is only used at the end, would it be possible to put in a "startup" routine for a nozzle that only starts bringing it up to temp a certain amount of time (estimated from printing speed) before it starts being u...

24c

IMHO Having this feature checked by default is the worst aspect of the software..... It just doesn't make sense. I pull my hair out, every. single. time. that-checkbox.png LMAO, I had exactly the same issue, and wondered why too, but you can get around it... by using this, and not having to re-impo...

24c

If I wanted to figure out how to write a tool change script that made a global speed change I guess that might somehow work, but I don't write G Code, that's why I purchased Simplify3D.... I bought Simplify3D for my RepRap dual extrusion printer, and I had to learn how to write GCode to get Simplif...

24c

I'm new to this, but surely the heads are related to a tool change, so can't you make a new condition when the new tool is selected either as a tool change script or a post process, that slows the print speed down globally? Simplistically, I am assuming you can do this with a GCode routine with your...

24c

Solved, I just deleted them all, after saving one.

Then I checked the .frm and edited the FFF profile by hand and re-imported them both, and problem solved, so not sure why it was happening, having found the affected area of code, but it's history now.

24c

Is it because you are adding a T0, as I'm sure if you do {TOOL0REPLACE "G1 E-4.0000 F6000\n" "T3\n G10\n"} this will work Another trick I learnt, if you want to invoke an event before a Tool Change in a Tool Change Script add a value like this "XXXX" XXXX G1 B0 T[new_to...

24c

I am trying to understand why if I create a process, select a profile with known temperature setpoints for layer 1 & 2, why selecting another extruder type say Extruder 1, Extruder 2 or All extruders, seems to corrupt the profiles temperature setpoints, and mine keeps defaulting back to 190ºC, w...

24c

OK, so three attachments are the limit, so here's the Profile and .frm file for a QuickFill equipped Robox

24c

OK, so I've corrected a few things, and done away with the Simplify3D Tool Change Script, and added a simplistic one I used in the DM profile (I will revisit this sometime, once I have uncooked the DM head..hmmm the joys of trying to do something different). I have tested it so far, and it is workin...

Search found 21 matches

Feature Request - Custom Command Panel

Re: a couple of ideas for dual extruder printing

Re: Dual extrusion with multiple groups?

Re: Separate support processes for dual extruder

Re: Separate support processes for dual extruder

Re: Temperature Setpoints

Re: Postprocessing command does not work

Temperature Setpoints

Re: CEL Robox Support

Re: CEL Robox Support