Search found 3 matches
- Tue Jun 23, 2020 8:20 am
- Forum: General Discussion and Tips
- Topic: Settings for printing tpu or ninjaflex
- Replies: 7
- Views: 11282
- Jump to post
Re: Settings for printing tpu or ninjaflex
I'm printing TPU from Creality and found the following: even with a perfectly calibrated extruder, the extrusion factor must be adjusted waaaay down, at the moment it is on 0.75! This is with a direct drive and a 0.6mm nozzle. I started at 1.00, but I kept getting blobs that got stuck to the nozzle ...
- Mon Jul 22, 2019 10:20 am
- Forum: Troubleshooting and Bug Reports
- Topic: Tempature overshoot and cant print ABS.
- Replies: 2
- Views: 2310
- Jump to post
Re: Tempature overshoot and cant print ABS.
I notices something similar on my CR10 S4, Marlin 1.1.9. Extruder temperature is regulated but bed temperature goes up until maximum. All other commands seem to work. Is there a solution to this? The bed temperature works fine when not controlled by the Machine Control Panel (USB disconnected )
- Tue Feb 12, 2019 9:52 am
- Forum: Troubleshooting and Bug Reports
- Topic: Top of supports appearing above object
- Replies: 1
- Views: 916
- Jump to post
Top of supports appearing above object
Interesting: 2 blades with different angle, one is supported correctly, the other shows a part of the support ABOVE the blade. The only solution here was to set the "lower vertical separation layers" to 7. The problematic angled blade is around 53 degrees.
