Search found 3 matches

Go to advanced search

by Sa1Wales
Sun Jun 23, 2019 6:44 am
Forum: Troubleshooting and Bug Reports
Topic: Unknown Command?
Replies: 0
Views: 316

Unknown Command?

When I connect to my A30 this is listed Attempting connection at \\.\COM3... READ: JumpToApp0 READ: JumpToApp1 READ: MACHINE_TYPE:A30 UUID:181206A30016614 FIRMWARE_NAME:V1.xx.58 READ: PROTOCOL_VERSION:V1.0 EXTRUDER_COUNT:1 READ: echo:SD card ok Connected to machine! Unknown command: Should I Just ig...
by Sa1Wales
Mon Jun 10, 2019 6:59 pm
Forum: Troubleshooting and Bug Reports
Topic: X and Y bed offsets
Replies: 2
Views: 310

Re: X and Y bed offsets

I'd suggest looking at this guide. https://www.simplify3d.com/support/faq/#faq-4616 If the homing location is (0,0,0), and is off the bed, you will want to give the origin an offset in Simplify3D. This will make it so that the generated G-Code is positioned correctly. Note: This will not automatica...
by Sa1Wales
Thu Jun 06, 2019 11:20 am
Forum: Troubleshooting and Bug Reports
Topic: X and Y bed offsets
Replies: 2
Views: 310

X and Y bed offsets

Hi I am used to using Cura but upgraded to Simplify 3D today, I use a Geeetech A30 and in the home position the nozel if off the bed so when simplify 3d starts the line to prime the nozle it is off the front of the bed. So my question is in which offset to I add the offsets. is it in the Machine Off...

Go to advanced search