print estimate

The estimate in the machine control panel uses the actual progress of the machine for the estimate. For example, if the print is 50% finished and it took 1 hour, the machine control panel will show 1hr remaining (2hrs total). Once ...

langweiler

... which is usually quite good and rather conservative. For the test print I am doing at the moment, the printer predicts a printing time of 59 minutes. The Simplify3D estimate is 110 min, which is way too much. How can I adjust/correct estimation? I suspect ...

The Machine Control Panel estimate is based on the elapsed time for the actual print. In your case, it took 27 minutes to make it to 11%, so it's reasonable to guess that it might take ...

rsworden59

... same issues you listed: - E-Stop button doesn't work. - No running estimate of time remaining or % done for currently running print. - No notification of total execution time when print finishes. - No live line tracking. ...

cote

Hi. Simplify3D V5 changed the comment from "Built time" to "Build Time" (note the capital T). In the case of Klipper firmware, it is enough to mess things up when it comes to parsing the slicer estimate.

regnaDkciN

... input boxes up/down arrows don't repeat with long press. - No running estimate of time remaining or % done for currently running print. - No notification of total execution time when print finishes. - No live line tracking. ...

gwhite

... mm increments. Unless you need an absolutely precise location, you can estimate the coordinates of the appropriate corner closely enough from that. If you print from outside-to-in, it's going to start at the nearest point on the outside of the ...

dkightley

... tab of settings) to fine tune the gap so that you get good adhesion of prints without getting the "elephants foot" effect, where plastic ... gauges are useless as they offer little resistance, and you can't estimate the resistance. Again....don't worry about exact distances in thou ...

zemlin

search.php?keywords=%22time+estimate%22

GrahamGunderson

... -> Communication tab, where it's easy to see Gcode being sent and the printer replying. Motional Gcode has two durations: 1) The estimated duration, based on assumptions within S3D / configuration settings in a future UI ...

Search found 125 matches: print estimate

Re: Remaining print time on Flashforge Creator 3 is incorrect

Remaining print time on Flashforge Creator 3 is incorrect

Re: Estimated printing time bug

Re: Several V5 issues, some major

Re: Print time remaining

Several V5 issues, some major

Re: "Choose Start Point Closest to Specific Location" HOW?

Re: Bed-nozzle height

Re: Estimated print time incorrect for Makerbot 5th gen

Re: Add accel and jerk settings for accurate build time calc.