Hello,
I installed the extra cooling fan with the mosfet to my CTC Replicator 1 with Sailfish 7.7 firmware. Tests over the Menu while the CTC is printing and over the Manual Mode in S3D result well, the Fan work.
I setup in S3D under Cooling, that the fan start at the first layer with 100%, created a .x3g file and printed it over SD Card. But the fan won't start.
Now I don't know, is it a problem from S3D or the Sailfish FW.
Is there someone, woh can help me? Thank U ver much!!
-
CompoundCarl
- Posts: 2005
- Joined: Wed Aug 05, 2015 7:23 am
Re: No extra Cooling fan with CTC
Well, what command gets sent from the machine control panel when you turn the fan on? (you said that works, right?)
Then create your x3g file and look for that same command. I would imagine it should be in there. If it is, then it's probably a firmware issue.
If the command isn't in your x3g file, then you can attach your factory file here and maybe others can help (file > save factory file)
Then create your x3g file and look for that same command. I would imagine it should be in there. If it is, then it's probably a firmware issue.
If the command isn't in your x3g file, then you can attach your factory file here and maybe others can help (file > save factory file)
