Re: e3d cyclops
sorry this confusion is my fault, i received both cyclops and chimera at the same time.. this setup was for cyclops (single nozzle). Sorry for the mix up
Re: e3d cyclops
here is my delta setup
-
prcdslnc13
- Posts: 7
- Joined: Fri Jul 04, 2014 12:22 pm
Re: e3d cyclops
What board are you using? Im dying to use my cyclops but Ive been hesitant to get it all going with the CRAMPS and machinekit. Any advice on activating the second axis and all that in the HAL and .ini?
Re: e3d cyclops
I have a bebopr++ with a pepper board, there was already a hal/ini built >.< sorry im not more help
