Page 2 of 2
Re: 4.1 No gcode created. Total print time 0
Posted: Sun Dec 02, 2018 11:17 am
by the dragonlord
I Have the same exact situation, It slices only the supports....this is an umbelievable issue...
S3D 4.1 on Win 10
What's happening???
p.s.
I have still tried to reset to "factory settings" S3D but it didn't work....
Re: 4.1 No gcode created. Total print time 0
Posted: Sat Dec 08, 2018 5:33 pm
by themrcaveman
Re: 4.1 No gcode created. Total print time 0
Posted: Mon Dec 17, 2018 7:40 am
by the dragonlord
Still no solution yet? How can it be possible that an error like this won't be fixed? It's not just me to experience it....
Re: 4.1 No gcode created. Total print time 0
Posted: Mon Dec 17, 2018 4:20 pm
by S3D-Alex
We have still not been able to reproduce anything resembling this issue so if you could please provide a Factory File where the issue occurs it would be very helpful.
Re: 4.1 No gcode created. Total print time 0
Posted: Tue Dec 18, 2018 12:52 am
by the dragonlord
I could give you a .factory but it would be unuseful because it happens with .factory created with the older version, the newer one and with all the downloaded files as well so the issue isn't for sure the factory file or at least it is not "stored" in it... I heard a guy from a company wich we collaborate with having the same issue with s3d upgraded from 4.0 to 4.1 directly...
Re: 4.1 No gcode created. Total print time 0
Posted: Tue Dec 18, 2018 4:19 am
by S3D-Jason
We still haven't been able to reproduce this issue on our end. As others said, the files posted in this thread seem to be slicing just fine.
We would be happy to continue investigating, but we need to gather more information from the individuals that are having this problem. If you are experiencing this issue, please contact us directly at the link below so that we can start discussing and gathering more detailed information.
https://www.simplify3d.com/contact-us/
