Page 2 of 2
Re: By golly, they listened! Honeycomb and full grid infill.
Posted: Mon Jun 22, 2015 10:23 pm
by jimc
actually this showed up right on time. it has only been a hair over 4mos since 2.2.2
3-4 mos has been the normal update schedule over the past 2 years. they really hit the ball out of the park on this one. they really listened and added the features that people were asking for.
Re: By golly, they listened! Honeycomb and full grid infill.
Posted: Tue Jun 23, 2015 1:58 am
by smartavionics
All good and dandy but they didn't fix the "failure to extend solid layers adequately above infill" bug that has been mentioned several times on this forum over the last 6 months. Do THEY read these postings, I have my doubts. Time for a direct email to support....
Re: By golly, they listened! Honeycomb and full grid infill.
Posted: Tue Jun 23, 2015 4:36 am
by dkightley
Whats needed now is for someone who has the right permissions on the forum to go through the feature request section and mark all of the addressed requests.
This serves two purposes....firstly it will give users an idea of what requested changes have been made...and secondly, will give an indication of how much influence the users (ie us) have in the development of the software.
Well done to the guys at S3D. How about a feature on the blog briefly running through the development process???
Re: By golly, they listened! Honeycomb and full grid infill.
Posted: Tue Jun 23, 2015 6:21 am
by JoeJ
smartavionics wrote:All good and dandy but they didn't fix the "failure to extend solid layers adequately above infill" bug that has been mentioned several times on this forum over the last 6 months. Do THEY read these postings, I have my doubts. Time for a direct email to support....
That has been fixed. See comparisons here:
viewtopic.php?f=23&t=1809&start=40#p11726
Re: By golly, they listened! Honeycomb and full grid infill.
Posted: Tue Jun 23, 2015 9:40 am
by DarthRevan
mushoo wrote:
• We can define Toolhead Offsets in S3D now. Not sure if there's a way to disable that, as I've got mine written into the firmware. Probably doesn't matter? Maybe I just leave at 0 when they're defined in firmware? Unsure.
There is a toggle button to apply the toolhead offsets. If I'm not mistaken, a majority of printers will not need them so it defaults to not applying them.
Re: By golly, they listened! Honeycomb and full grid infill.
Posted: Thu Jul 09, 2015 6:39 pm
by dkightley
Whats needed now is for someone who has the right permissions on the forum to go through the feature request section and mark all of the addressed requests.
This serves two purposes....firstly it will give users an idea of what requested changes have been made...and secondly, will give an indication of how much influence the users (ie us) have in the development of the software.
And I'm so glad to see that someone is doing exactly that! Its a thankless task that causes a short term nightmare for anyone trying to follow what's going on......but the long term benefit will be a much clearer picture of what the users are requesting.
A big thumbs up to the support team. Well done!
