Simplify3D User Forum

Posted: **Mon Mar 28, 2016 4:00 pm**

To quote myself:

An alternative...or even a supplement to a brim....is using "mouse ears", small two or three layer sacrificial discs that you place on the print bed just on the edge of your model, joined either by overlapping your model or by small connecting strips.

Posted: **Mon Mar 28, 2016 4:48 pm**

Thanks for reiterating, these were the results. maybe I need to add two more mouse ears to each end at the corners?

Pic1
Pic2
Pic3
Pic4

Posted: **Tue Mar 29, 2016 2:31 am**

Have you tried blue painter's tape wiped with isopropyl alcohol (IPA)?

I get very good adhesion of PLA even for long thin parts using tape and IPA on a heated bed.

Cheers,

Mark

Simplify3D User Forum

Ends on long piece lifting?

Re: Ends on long piece lifting?

Re: Ends on long piece lifting?

Re: Ends on long piece lifting?