Page 2 of 3
Re: V 4.0.1 Start point to specific location works not anymo
Posted: Mon Dec 25, 2017 10:17 am
by dkightley
Perhaps a summary of the finding (I'm confused as to exactly what the issue is) will help the devs to diagnose and resolve the issue.....
An easy hit is an easy hit!
Re: V 4.0.1 Start point to specific location works not anymo
Posted: Mon Dec 25, 2017 11:45 am
by blackbird2016
As mentioned in the 1st post.
To specify the start point closest to a given point does not work anymore in 4.0.1
unless "Print Island Sequentially without optimization" is UNCHECKED
Re: V 4.0.1 Start point to specific location works not anymo
Posted: Mon Dec 25, 2017 2:16 pm
by horst.w
Hi,
I don't believe it!
Here are attached another exemple with settings as every day, only the ooze shield is set for demonstration and shows definitivly the startpoint near X0 / Y0 and near X200 / Y200 when the print head changes between the model and the ooze shield.
The 3rd picture shows the same with setting to Random Start Point.
S3D 4.0.1 on Win 7 Prof.
H.
Re: V 4.0.1 Start point to specific location works not anymo
Posted: Mon Dec 25, 2017 7:21 pm
by NitroXpress
With sequentially print checked or unchecked ?
Re: V 4.0.1 Start point to specific location works not anymo
Posted: Tue Dec 26, 2017 2:39 am
by horst.w
... without sequentially print. This option has no influences to my results.
Here is the real existing print:
The objects high is 6 mm and the nobbles are caused only by my settings without a Restart value (normal used -0,13 for ABS and PLA but this is a new special filament. Lift also set to zero).
H.
Re: V 4.0.1 Start point to specific location works not anymo
Posted: Thu Dec 28, 2017 3:00 pm
by dkightley
Re: V 4.0.1 Start point to specific location works not anymo
Posted: Sun Feb 25, 2018 7:55 pm
by zemlin
Another example:
I have the start point set near the center of the part - offset slightly to one side so i should get a 'zipper' up the side. i don't want any start points on the vanes. here's what it looks like in 4.0 (this is what i want to have)
If i slice this in 4.1 I get scattered start points, and some of them are out on the vanes which clearly are not the closest point to the specified coordinates.
Re: V 4.0.1 Start point to specific location works not anymore
Posted: Sat Jul 14, 2018 9:40 pm
by jonah1978
This is not fixed yet? I am having the same issue. I haven't had to print anything for a long time where i needed specific start points. Now I go to do it and it doesn't work anymore.
Is there a fix?
Re: V 4.0.1 Start point to specific location works not anymore
Posted: Sun Jul 15, 2018 2:27 pm
by zemlin
jonah1978 wrote: ↑Sat Jul 14, 2018 9:40 pmIs there a fix?
My work-around is still 4.0.
Re: V 4.0.1 Start point to specific location works not anymore
Posted: Mon Jul 23, 2018 6:24 am
by jonah1978
I would do that, but I no longer have the 4.0 install file.
