How to slow down the X/Y printing during fill?- SOLVED

[KC_703]

Maybe that's the lowest layer height recommended for the machine. Getting under .1 is ambitious for any FDM machine. If you're trying to achieve a smooth as glass finish... that's better achieved with a SLA type printer.

Looking at the print from the other machine, its not completely artifact free... it may be a little better than the current machine. But honestly, both prints are pretty good. My eye may not be the best for critique of fine surface finish... I usually print at .3 layer height with a .5 nozzle because I'm impatient.

[JasonA]

I hear yeah... these parts and other things are going out to friends and clients so I want them to look the best!

I can wait awhile for them to print but everyone on here has been awesome at helping me through all this and my first steps at S3D!

It's an amazing program!

Thanks again for all your help everyone and I hope to contribute myself!

Jason

P.S. we can mark this as solved