duplicate printing (dual extruders)
Posted: Fri Aug 03, 2018 5:38 am
I have bought a Sigmax printer from BCN3D that can print a duplicate of a model (mirror mode) ie. two extruders print simultaneous two copies of the same model. I can set this up in Cura, but I prefer to work with S3D, as I use many processes in my print. Is there any way I can set it up in S3D? 
I need to add that I am not very good in G-code, so if it is where it can be done, then it would be great if any of you can provide the code lines.
I need to add that I am not very good in G-code, so if it is where it can be done, then it would be great if any of you can provide the code lines.