I need to add that I am not very good in G-code, so if it is where it can be done, then it would be great if any of you can provide the code lines.duplicate printing (dual extruders)
I have bought a Sigmax printer from BCN3D that can print a duplicate of a model (mirror mode) ie. two extruders print simultaneous two copies of the same model. I can set this up in Cura, but I prefer to work with S3D, as I use many processes in my print. Is there any way I can set it up in S3D? I need to add that I am not very good in G-code, so if it is where it can be done, then it would be great if any of you can provide the code lines.
I need to add that I am not very good in G-code, so if it is where it can be done, then it would be great if any of you can provide the code lines.Re: duplicate printing (dual extruders)
Lisberg,
Welcome to the Simplify3D user forum. Our support team would be more than happy to help you achieve this. Have you submitted a support request through our "contact us" page?
Welcome to the Simplify3D user forum. Our support team would be more than happy to help you achieve this. Have you submitted a support request through our "contact us" page?
"A bird does not sing because it has an answer. It sings because it has a song."
