Any work being done on Afinia H470 / Up Plus?
Posted: Sun Jun 01, 2014 4:46 pm
by techknight
I'd be interested in trying out Simplify3D on my Afinia H479 if it could be made to work.. I'm reasonably happy with how their proprietary software slices, but users can't set a nozzle/platform temp other than 210/50 and 270/100!
Re: Any work being done on Afinia H470 / Up Plus?
Posted: Mon Jun 02, 2014 10:41 pm
by teamcarlisle2
The only way you could get "any" software to work with the Afinia/Up! ,other than the proprietary software made for it, would require you to strip out the electronic main board and cpu, and install your own. It's has been done by a few people if you go to the pp3dp forums. But I wouldn't recommend it unless your original cpu/main board is dead. For abs prints, I still haven't used any slicer better that Afinia/Up! (Although S3D is faster, it doesn't produce as nice prints) And for PLA it's not bad either