Failed to parse XML
Posted: Wed Apr 24, 2019 12:29 pm
by nfol
Sometimes, I get the attached message when I start-up S3D or when I try to load a factory file.
Is that a known bug?
Re: Failed to parse XML
Posted: Wed Apr 24, 2019 3:32 pm
by dkightley
Re: Failed to parse XML
Posted: Thu Apr 25, 2019 4:38 pm
by nfol
Thank you very much for your reply.
It solved my problem: I had the special Nordic letter æ ( a and e combined) in the file name.
I use a lot of different programs and did not come across that kind of problems since the DOS era. I can see in the other thread, that it has been known for a long time. Too bad.