Simplify3D User Forum

Hello i have just buyed simplify3d. i hope my settings are all correct but my Printer doesn´t print.
I Hve a Nophead Mendel90 and after these gcodes nothing happens
RECEIVED: T:29.81 E:0 B:83.0
RECEIVED: T:29.97 E:0 B:83.2
RECEIVED: T:29.97 E:0 B:83.4
RECEIVED: T:29.88 E:0 B:83.7
RECEIVED: T:29.88 E:0 B:83.8
RECEIVED: T:29.94 E:0 B:84.1
RECEIVED: T:30.00 E:0 B:84.3
RECEIVED: T:30.05 E:0 B:84.5
RECEIVED: T:30.00 E:0 B:84.7
RECEIVED: T:29.88 E:0 B:85.0
RECEIVED: ok
SENT: M105
RECEIVED: ok T:29.9 /0.0 B:85.0 /85.0 @:0%

you see the bed is heating up but after that nothing happens
Please help me

Could you upload a gcode file you're trying to print? Maybe someone can take a look at it

I have a FlashForge 3D Pro and I see this all of the time, usually after I abort a print job or if a try to start a job when the printer is not at the top level menu. it usually requires that I reboot the computer and / or power cycle the printer. This is very frustrating as it can take several minutes to get it talking to the printer again and by then the extruder and the build plate have cooled off and then you need to wait for them to heat up again.

Hello!
Same problem with my Mendel 90 printer and vers. 2.1.0 . If I then press button "force next" the printer continues to heat up the nozzle,then the bed and then it is starting the startgcode. But then the extruder produces lines with different width and collection of print material and the extruder moves forward an backwards and sometimes slipping through. I had to stop the print job.
What mistakes I have made, please help ? I attached the profile of my Mendel90
Manfred

Hi, I have a kloner3d 240 and I have the same problem. It happens when I start simplify the first time, then it is all right

Mendel90 Nophead S3D 2.2.1 the same problem. After pressing "Force Next" it prints very well via USB.

If you have a heated be turn it on at a low temp. It should start then. That works for me every time.

Edit: Just saw you have a heated bed. Dual extruders?