Simplify 4.1.2 problems with Anycubic Chiron
Posted: Tue Oct 22, 2019 5:36 am
Hello, everyone,
I've just identified the following problem.
I wanted to print this lamp with the Chiron.
Link: https://www.myminifactory.com/object/3d ... rsion-6019
Since I have enough space with the Chiron I print them vertically on the printing platform and then adjusted to 0.1mm layer height. When calculating Simplify always crashes again!
With layer height 0.2mm everything works!
Why is this possibly a Buck in the program !?
Greetings Skink
I've just identified the following problem.
I wanted to print this lamp with the Chiron.
Link: https://www.myminifactory.com/object/3d ... rsion-6019
Since I have enough space with the Chiron I print them vertically on the printing platform and then adjusted to 0.1mm layer height. When calculating Simplify always crashes again!
With layer height 0.2mm everything works!
Why is this possibly a Buck in the program !?
Greetings Skink