FlashForge Guider II File Upload
Posted: Wed Jun 03, 2020 12:26 pm
Hi All,
I'm very new to the 3D printing world and I'm having a tough time getting my print file from Simplify3D to the Guider II via a flashdrive. I upload the print file to the flashdrive, but once I've selected it on the Guider II, it gives me a message that says "not resume file" and the lights cut off. I've also noticed that the test file on the flashdrive was a .gx file while the file I'm uploading is a gcode file. I'm assuming this is related but struggle to type in anything to google/youtube that is useful to fix.
Does this make sense, or sound familiar to anyone? any advice or input is welcome!
Stay safe and healthy
I'm very new to the 3D printing world and I'm having a tough time getting my print file from Simplify3D to the Guider II via a flashdrive. I upload the print file to the flashdrive, but once I've selected it on the Guider II, it gives me a message that says "not resume file" and the lights cut off. I've also noticed that the test file on the flashdrive was a .gx file while the file I'm uploading is a gcode file. I'm assuming this is related but struggle to type in anything to google/youtube that is useful to fix.
Does this make sense, or sound familiar to anyone? any advice or input is welcome!
Stay safe and healthy