Page 1 of 1
Paths outside the model
Posted: Tue Sep 29, 2020 7:24 am
by Mavashi
Hello everyone,
My prints have paths outside the model. The problem is visible in the photos I atached. How I can fix this issue?
Re: Paths outside the model
Posted: Tue Sep 29, 2020 12:57 pm
by S3D-Jake
These are preview visualizations of retractions. On the left you can toggle retractions on or off for the preview window.
Re: Paths outside the model
Posted: Wed Sep 30, 2020 2:07 am
by Mavashi
These are preview visualizations of retractions. On the left you can toggle retractions on or off for the preview window.
You are right. So if retractions are visible on the prints as seen in the photo I must change retraction options?
Re: Paths outside the model
Posted: Wed Sep 30, 2020 4:14 pm
by S3D-Jake
Yes! Your profile's extruder tab's retraction settings need altered.
Solving issues with blobs and zits:
https://www.simplify3d.com/support/prin ... -and-zits/