Page 1 of 1
filament cant out
Posted: Fri Oct 24, 2014 3:33 am
by rioono
hello.. im new in s3d..
i have troubleshooting with my replicator2, i cant print anything coz my filament cant' out.. anyone can solve it?
thx b4
Re: filament cant out
Posted: Fri Oct 24, 2014 6:19 am
by JoeJ
Is the extruder jammed?
Re: filament cant out
Posted: Fri Oct 24, 2014 11:06 am
by rioono
JoeJ wrote:Is the extruder jammed?
no, if i load or unload filament can out.. but if i print something filament wont out and after clean extruder nothing happen
Anyone, if i instal S3D on replicator2 the firmware must be change with sailfish or not??
THX
Re: filament cant out
Posted: Sun Oct 26, 2014 2:35 pm
by JoeJ
I use it on a Rep2 with the stock firmware (NOT sailfish) and it works fine