Tool changes while printing with support material
Posted: Mon Jan 25, 2021 5:06 pm
Hi everyone,
I am trying to optimize the cycle time of my print which is a dual extruder print using soluble support material on the second one.
I want S3D to change tools as few times as possible, exactly like it does for dual prints where it does the following:
ABBAABBAAB....
currently it goes ABABABABAB.... which adds up to double the tool changes.
Is there a way to change this?
Thanks!
Rob
(sorry if there is a thread about this already but I couldn't find anything)
I am trying to optimize the cycle time of my print which is a dual extruder print using soluble support material on the second one.
I want S3D to change tools as few times as possible, exactly like it does for dual prints where it does the following:
ABBAABBAAB....
currently it goes ABABABABAB.... which adds up to double the tool changes.
Is there a way to change this?
Thanks!
Rob
(sorry if there is a thread about this already but I couldn't find anything)
