Tool changes while printing with support material

[Rob B. - PTI]

Hi everyone,
I am trying to optimize the cycle time of my print which is a dual extruder print using soluble support material on the second one.

I want S3D to change tools as few times as possible, exactly like it does for dual prints where it does the following:
ABBAABBAAB....

currently it goes ABABABABAB.... which adds up to double the tool changes.
Is there a way to change this?

Thanks!
Rob

(sorry if there is a thread about this already but I couldn't find anything)

[Rob B. - PTI]

No input on this?
Can't imagine I'm the only one trying to do this...

[Daniel]

i find something about this but i dont remember which tread it is
i'm going to look at it