Simplify3D User Forum

Posted: **Fri Nov 07, 2014 9:22 am**

Hello everyone,
I am interested in using Simplify3D with my MakerBot Replicator Dual. Is this possible ?
I also have a Kossel Clear Delta printer from Kickstarter which you can see here:
https://www.kickstarter.com/projects/bl ... ta-3d-prin
Can I use Simplify3D on the delta too?

Posted: **Fri Nov 07, 2014 2:59 pm**

Yep, both of these printers work with Simplify3D. The rep 2 is on the list of printers one click and your setup, and for the kossel, I'd recommend just using the SeeMeCNC Orion profile to start off with and use that as a base.

Posted: **Fri Nov 07, 2014 3:31 pm**

Sorry I'm confused. the Rep 2 is not the Rep Dual. The Rep Dual is the wood construction with two heads. First was the Replicator then the Dual then the Rep 2, then the Rep 2x, and now the 5th generation. The supported printers states Rep 1, Rep 2 and Rep 2x.

Posted: **Mon Nov 10, 2014 9:56 am**

It works with a Replicator Dual, aka rep1

Simplify3D User Forum

MakerBot Replicator Dual and a Delta with Simplify3D

MakerBot Replicator Dual and a Delta with Simplify3D

Re: MakerBot Replicator Dual and a Delta with Simplify3D

Re: MakerBot Replicator Dual and a Delta with Simplify3D

Re: MakerBot Replicator Dual and a Delta with Simplify3D