V5 duet/reprapfirmware support ?
Posted: Wed Dec 14, 2022 10:12 pm
Does v5 support duet / reprapfirmware firmware ?
Simplify3D User Forum
Simplifying the 3D Experience!
https://forum.simplify3d.com/
V5 duet/reprapfirmware support ?
Page 1 of 1
Re: V5 duet/reprapfirmware support ?
Posted: Thu Dec 15, 2022 3:23 am
I am looking for this as well, I cannot find it
Re: V5 duet/reprapfirmware support ?
Posted: Thu Dec 15, 2022 3:23 am
Also looking for this? Does upload to Duet work over ethernet?
Re: V5 duet/reprapfirmware support ?
Posted: Thu Dec 15, 2022 7:45 am
I've installed V5 just today and the software doesn't find any Duet 3D printers.
If I set the IP address manually, it prompts "connection error".
If I set the IP address manually, it prompts "connection error".
Re: V5 duet/reprapfirmware support ?
Posted: Fri Dec 16, 2022 8:26 am
You can Slice for Duet / RepRap, but you can't upload directly.
Or at least I wasn't able to establish a network connection to the Duet Mini5+ up to now.
Slicing and printing works fine, but you need to upload manually (Save to Harddisk and upload via Browser)
I don't know why its not implemented, PRUSA Slicer (FOC!) is able to do it since years...............
Nevertheless, the print looks good so far and seems to be a bit faster.
BR
Gountled
Or at least I wasn't able to establish a network connection to the Duet Mini5+ up to now.
Slicing and printing works fine, but you need to upload manually (Save to Harddisk and upload via Browser)
I don't know why its not implemented, PRUSA Slicer (FOC!) is able to do it since years...............
Nevertheless, the print looks good so far and seems to be a bit faster.
BR
Gountled