Page 1 of 1
Connect hangs with Printrbot/Printrboard?
Posted: Wed May 15, 2013 6:38 pm
by pedroleite
I have a printrbot jr. altough it's a marlin, the connection hangs using Creator and doesn't with Repetier-host... using Mac Os X 10.8.3
Any recommendations?
Re: Connect hangs with Printrbot/Printrboard?
Posted: Sat May 18, 2013 12:48 pm
by Simplify3D
What baud rate are you using? Can you post the communication log from Creator so we can see if there is any commands being sent back and forth.
Re: Connect hangs with Printrbot/Printrboard?
Posted: Mon Jul 08, 2013 5:57 pm
by pedroleite
As far as I can see it doesn't start the communication at all.
If I do connect with Repetier or OctoPrint even it does so.