Corrupt gcode over wifi for version 5.0.2
Posted: Sun Mar 12, 2023 2:10 pm
I've reported a problem to support but have not gotten a resolution. I was wondering if anyone else is experiencing this error.
I've tried to print two separate models over wifi to my connected Qidi X-Pro printer. I run an Eero wifi mesh network. The printer is about 6 feet from the router. On both occasions, the printer errors out with:
and
The models print correctly if I save them to usb and insert into the printer to print.
Has anyone had similar issues? Have you resolved them?
I've tried to print two separate models over wifi to my connected Qidi X-Pro printer. I run an Eero wifi mesh network. The printer is about 6 feet from the router. On both occasions, the printer errors out with:
Code: Select all
Illegal gcode in line:xxxx, P_4, T_10470103!Code: Select all
Illegal gcode n line: xxxx, P_4, T_10470000!Has anyone had similar issues? Have you resolved them?