Any plans to support Mingda and UP?
Posted: Sat Feb 21, 2015 4:48 pm
As per the title, just wondering.
Simplify3D User Forum
Simplifying the 3D Experience!
https://forum.simplify3d.com/
Any plans to support Mingda and UP?
Page 1 of 1
Re: Any plans to support Mingda and UP?
Posted: Sat Feb 21, 2015 8:19 pm
I would like to know that as well. Bought a Mingda a few months ago and Simplify3d and I havent been able to print anything decent with it
Re: Any plans to support Mingda and UP?
Posted: Sun Feb 22, 2015 5:43 am
The Mingda printer lists their software as being compatible with other open-source slicers, so I imagine it would also accept Simplify3D gcode.
The Up! will probably never be supported as it uses all proprietary stuff.
The Up! will probably never be supported as it uses all proprietary stuff.
Re: Any plans to support Mingda and UP?
Posted: Sat Feb 28, 2015 3:15 am
Looks like that's the case, I emailed them about using Simplify3D and this was their reply -JoeJ wrote:The Mingda printer lists their software as being compatible with other open-source slicers, so I imagine it would also accept Simplify3D gcode.
"Yes, our 3D printer is also compatible with G-code, so you can use the simplify3D software to help with your work. (Normally, we use CURA software for slicing)"
Interesting .....
Re: Any plans to support Mingda and UP?
Posted: Wed Jan 13, 2016 5:03 am
hI
Good profile for Mingda Glitar 6c,,,For different model only change printing volume( Hight of print ) ,,If you need firmware,display drivers or Win drivers be free to ask,,
Good profile for Mingda Glitar 6c,,,For different model only change printing volume( Hight of print ) ,,If you need firmware,display drivers or Win drivers be free to ask,,
Re: Any plans to support Mingda and UP?
Posted: Wed Jan 13, 2016 5:12 am
settings
Re: Any plans to support Mingda and UP?
Posted: Wed Jan 06, 2021 5:10 pm
@edvardrahelic - Do you still have software for the Glitar 6c (firmware, drivers)? Thx 