Simplify3D User Forum

Posted: **Tue Mar 03, 2015 2:02 pm**

There are gaps between the filament on the top and bottom layers. The attached images were lit from the bottom to better show the problem. Any suggestions? Thanks.
Replicator 2 w/ Bottleworks HBP
PLA 210 deg, HBP 70 deg

Posted: **Sun Mar 08, 2015 12:06 pm**

If the top and bottom layers both have gaps, then you might want to increase the extrusion multiplier by 0.05

Simplify3D User Forum

Gaps between filament on top and bottom layers

Gaps between filament on top and bottom layers

Re: Gaps between filament on top and bottom layers