Simplify3D User Forum

Posted: **Sat Jul 01, 2023 7:39 am**

Hello,
In Cura we can pass the temperature of bed and hotend with this line in the PRINT-START macro :
PRINT_START BED={material_bed_temperature_layer_0} HOTEND={material_print_temperature_layer_0}

In simplify3D i did not find the two variables.
Anybody can help me ?

Posted: **Mon Jul 03, 2023 12:37 pm**

Many of the available variables are listed here:
viewtopic.php?f=8&t=1959

I believe you want [extruder0_temperature] and [bed0_temperature]

Posted: **Fri Jul 07, 2023 10:19 am**

Hello jason,
Excuse me for the delay, i thought i asked to see the answer.
I try that but i think you give me the good solution.
Thank you.

Update:
Wonderful !
PRINT_START BED=[bed0_temperature] HOTEND=[extruder0_temperature]
Thanks a lot Jason.

Simplify3D User Forum

Passing Slicer Variables to a Macro PRINT-START

Passing Slicer Variables to a Macro PRINT-START

Re: Passing Slicer Variables to a Macro PRINT-START

Re: Passing Slicer Variables to a Macro PRINT-START