Simplify3D User Forum

Posted: **Tue Mar 17, 2015 9:40 am**

Hi!

When I print and use the Override Boxes to enter a new value for Movement or Extrusion override, every value gets directly submitted.
So when i enter 100 (via keyboard) first 1 then 10 then 100 is send to the printer.
The bad thing is when the printer is on a long path and receives the 1% movement overide.

Better would be only to send out the command when changing focus and/or when hitting enter (better both)

Posted: **Tue Mar 24, 2015 3:49 pm**

you won't run into this issue when using the dials or the up and down arrows.

Posted: **Wed Mar 25, 2015 5:10 pm**

Interesting.. i have always used the dials, never manually.. good to know.

Posted: **Thu Mar 26, 2015 8:54 am**

DarthRevan wrote:you won't run into this issue when using the dials or the up and down arrows.

yeah but when setting back from 150% to 100 it's the most simple way to just enter 100?
you could click 50 times on the down arrow
or grab the well and try to dial in 100%,
where you get every setting from 95 to 105 within the process send to the printer.

Simplify3D User Forum

Movement Extrusion Override Settings are directly applied

Movement Extrusion Override Settings are directly applied

Re: Movement Extrusion Override Settings are directly applie

Re: Movement Extrusion Override Settings are directly applie

Re: Movement Extrusion Override Settings are directly applie